Standard Equipment

• Firm metallic structure.
  
• Working area 3.1m x 1.6m.
• Water bed for keeping the sheet cool and even without emitting fumes
• Servo motors at all axis.
• 2 servo motors at Υ axis.
  
• 1 servo motor at Χ.
• 1 servo motor at Ζ.
• 8 bearings support the bridge, 4 bearings at each side (be aware  that most machines use only 2 bearings at each side).
  
• Special system guarantees the perfect engage between rack and pinion.
  
• All moving parts are covered by special items, limited need for maintenance.
• Accurancy (via mathematical equations) 0.00108mm and 0.000435mm (according to encoder).
• Repeatability 0,0009625mm.
• Accurancy measured with a digital instrument 0,05mm.
  
• Smallest axis movement 0.001mm.
• Moving and operating speed 20m/min.
• Bearings at all axis.
  
• All cables are protected by energy chains.
• Digital switches at all axis.
  
• Special cables with reduced EMC noise.
  
• Special covers at the end of the working area keep the dust away from the moving parts.
• Control made out of  ΑΒΒ electronics.
  
• Special table made out from blades that are easy to be replaced after extended wear.
  
• Embedded PC with a  19'' touch screen at a stand alone control tower.
  
• Machine can operate in  2D, 2,5D.
• The operating software inspects the machine at all times and outputs error messages displaying where the fault is.  
• Cutting speed can be adjusted even when the machine is in operation.
• The software reads operating speeds and spindle speeds from the G-code.
• During operation the machine can be paused or stopped and then it can continue the operation from the same point.
  
• Emergency buttons.
• Low power consumption.
• Almost zero maintenance needed.
  
• Power 380V 3-phase.
• Weight 1200kg.

Optional Extras

• Fumes suction.
  
• CAM software for 2D operations.
  
• DTHC (Digital Torch Height Control) system that measures the distance between the torch and the sheet and keeps it steady during operation in order to achieve quality cut.  

video here